Cisco ONS 15454 Hardware Installation Manual page 456

NTP-G264 Perform the ONS 15454 M6 Shelf Installation Acceptance Test
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
If you installed an ONS 15454 M6, complete the following table by verifying that each applicable procedure
was completed.
Table 40: ONS 15454 M6 Shelf —ETSI Rack Installation Task Summary
Description
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454 M6 Shelves,
on page 20
NTP-G252 Install the ONS 15454 M6 Shelf , on page 294
Connect the chassis to the office ground. For detailed instructions on how to ground the chassis,
see the Electrostatic Discharge and Grounding Guide for Cisco CPT and Cisco ONS
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf , on page 327
NTP-G253 Install the ECU or ECU-S Module, on page 349
NTP-G524 Install the Power Modules in the ONS 15454 M6 Shelf , on page 355
NTP-G255 Install the LCD Module in the ONS 15454 M6 Shelf, on page 366
NTP-G256 Install Power and Ground to the ONS 15454 M6 Shelf , on page 370
NTP-G257 Install the Fan-Tray Assembly in the ONS 15454 M6 Shelf, on page 388
NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card, on page 261
NTP-G308 Connect the ONS 15454 M6 Multishelf Node and the ONS 15454 M6 Subtending
Shelves, on page 407
NTP-G309 Connect the ONS 15454 M6 and the ONS 15454 in a Mixed Multishelf Configuration,
on page 409
NTP-G310 Upgrade the ONS 15454 Multishelf Configuration Using the ONS 15454 M6 , on
page 419
NTP-G298 Configure a Cisco Catalyst 2950 or Catalyst 3560 (Active and Standby) for a ONS
15454 Multishelf Node, on page 152
Cisco ONS 15454 Hardware Installation Guide
426
Voltmeter
Applicable procedures in
Required
Onsite
None
(as applicable)
(as applicable)
(as applicable)
(as applicable)
Installing the ONS 15454 M6 Shelf
Installing the ONS 15454 M6 Shelf, on page 271
Completed
Platforms.