Cisco ONS 15454 Hardware Installation Manual page 170

Hide thumbs Also See for ONS 15454:

Table of Contents

NTP-G301 Connect the ONS 15454 Multishelf Node and Subtending Shelves to an MS-ISC-100T Card

Figure 65: Connecting the EAP to the Node Controller and Subtending Shelf

To connect a subtending shelf to the EAP, complete the following (see

Node Controller and Subtending Shelf, on page

a) Using a cross-over (CAT-5) LAN cable, plug one connector into the front panel of the subtending shelf

TCC2/TCC2P/TCC3 card in Slot 7 and plug the other end into the SSC1 port on the left EAP.

b) Using a cross-over (CAT-5) LAN cable, plug one connector into the front panel of the subtending shelf

TCC2/TCC2P/TCC3 card in Slot 11 and plug the other end into the SSC1 port on the right EAP.

c) Repeat Steps a and b for each subtending shelf in the multishelf configuration. Use the same SSC port

number (2 through 8) on the left and right EAP for each subtending shelf.

Cisco ONS 15454 Hardware Installation Guide

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf

Figure 65: Connecting the EAP to the