Cisco ONS 15454 Hardware Installation Manual page 450

DLP-G687 Upgrade the ONS 15454 Multishelf with the Catalyst 2950 Switch Configuration
Stop. You have completed this procedure.
DLP-G687 Upgrade the ONS 15454 Multishelf with the Catalyst 2950 Switch
Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Use TCC3 cards in ONS 15454 node controller while connecting it to the ONS 15454 M6 subtending shelves
and when there are more than 12 subtending shelves.
Procedure
Step 1
Disconnect the subtending shelf at Port 21 of the active and standby Catalyst 2950:
a) Remove the cross-over (CAT 5) LAN cable from Port 21 of the active Catalyst 2950.
b) Remove the cross-over (CAT 5) LAN cable from Port 21 of the standby Catalyst 2950.
Step 2 Connect the extended Catalyst 3560 (active and standby) to the Catalyst 2950:
a) Using a cross-over (CAT-5) LAN cable:
b) Using a cross-over (CAT-5) LAN cable:
Cisco ONS 15454 Hardware Installation Guide
420
Use this task to upgrade the existing ONS 15454 multishelf with Catalyst 2950
configuration, with the ONS 15454 M6 subtending shelves and Cisco Catalyst
3950.
• Two Cisco Catalyst 3560 switches must be installed in same rack as the node
controller shelf; refer to the Cisco Catalyst 3560 product documentation for
installation instructions.
• Cross-over (CAT-5) LAN cables
• NTP-G15 Install the Common Control Cards, on page 131
• NTP-G313 Install and Configure the TNC, TNCE, TSC, or TSCE Card, on
page 261
As needed
Onsite
None
• • Plug one connector to Port 1 of the extended Catalyst 3560 (active).
• Plug the other connector to Port 21 of the active Catalyst 2950.
• • Plug one connector to Port 1 of the extended Catalyst 3560 (standby).
• Plug the other connector to Port 21 of the standby Catalyst 2950.
Installing the ONS 15454 M6 Shelf