Ntp-G6 Install The Mic-A/P And Mic-T/C/P Fmecs (Etsi Only) - Cisco ONS 15454 Hardware Installation Manual

NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only)

NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning
Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock,
keep hands and fingers out of the power supply bays and backplane areas. Statement 166
Caution Always use the supplied ESD wristband when working with a powered ONS 15454 ETSI. For detailed
instructions on how to wear the ESD wristband, refer to the
Cisco CPT and Cisco ONS Platforms
Note
The ONS 15454 ETSI EFCA has 12 FMEC slots numbered sequentially from left to right beginning with Slot
18. Slots 18 to 22 and 25 to 29 provide electrical connections for the corresponding slots, so they are
unnecessary in DWDM applications.
Procedure
Step 1 Ensure that you are installing the FMECs in the correct slot:
• FMEC Slot 23 supports the MIC-A/P.
The MIC-A/P card provides connection for the BATTERY B input, one of the two possible redundant power
supply inputs. It also provides connection for eight alarm outputs (coming from the TCC2/TCC2P/TCC3
card), sixteen alarm inputs, and four configurable alarm inputs/outputs.
• FMEC Slot 24 supports the MIC-C/T/P.
Cisco ONS 15454 Hardware Installation Guide
66
This procedure installs the MIC-A/P and the MIC-T/C/P FMECs in the EFCA.
The EFCA is located at the top of the ONS 15454 ETSI shelf. It provides
connection for installing power, external alarms, timing input and output, and
craft interface terminals.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
FMECs (the MIC-A/P and MIC-T/C/P)
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), on page 60
Required
Onsite
None
.
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Electrostatic Discharge and Grounding Guide for