Ntp-G4 Open And Remove The Fmec Cover (Etsi Only) - Cisco ONS 15454 Hardware Installation Manual

NTP-G4 Open and Remove the FMEC Cover (ETSI Only)

b) Lift the door from its hinges at the top left corner of the door.
Figure 35: Removing the ONS 15454 ANSI Front Door
Step 3
Return to your originating procedure (NTP).
NTP-G4 Open and Remove the FMEC Cover (ETSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 Hardware Installation Guide
60
• To detach the other end of the ground strap from the longer screw on the fiber guide, loosen the #4
Kepnut (49-0337-01) on the terminal lug using the open-end wrench. Remove the terminal lug and
lock washer.
This procedure opens and removes the FMEC cover on the ONS 15454 ETSI.
The ONS 15454 ETSI has a screw-in panel over the EFCA. The FMEC cover
protects the FMEC cards.
Medium slot-head screwdriver
NTP-G306 Install the ONS 15454 Shelf, on page 31
Required
Onsite
None
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf