Cisco ONS 15454 Hardware Installation Manual page 31

Overview
This chapter provides an overview of the Cisco ONS 15454 (ANSI and ETSI), ONS 15454 M2 and ONS
15454 M6 shelf install.
Note
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI M12 shelf assemblies.
Note The Cisco ONS 15454 shelf assemblies are intended for use with telecommunications equipment only.
•
•
•
•
•
Compliance Standards
Install the ONS 15454, ONS 15454 M2 and ONS 15454 M6 shelves in compliance with your local and national
electrical codes:
• United States: National Fire Protection Association (NFPA) 70; United States National Electrical Code.
• Canada: Canadian Electrical Code, Part I, CSA C22.1.
• Other countries: If local and national electrical codes, are not available, refer to IEC 364, Part 1 through
Cisco ONS 15454 ANSI
When installed in an equipment rack, the ONS 15454 ANSI assembly is typically connected to a fuse and
alarm panel to provide centralized alarm connection points and distributed power for the ONS 15454 ANSI.
Fuse and alarm panels are third-party equipment and are not described in this documentation. If you are unsure
about the requirements or specifications for a fuse and alarm panel, consult the user documentation for the
related equipment. The front door of the ONS 15454 ANSI allows access to the shelf, fan-tray assembly, and
Compliance Standards, on page 1
Cisco ONS 15454 ANSI, on page 1
Cisco ONS 15454 ETSI, on page 2
Cisco ONS 15454 M2 Shelf, on page 2
Cisco ONS 15454 M6 Shelf, on page 4
Part 7.
1
C H A P T E R
Cisco ONS 15454 Hardware Installation Guide
1