Cisco ONS 15454 Hardware Installation Manual page 424

DLP-G655 Route and Lock Cables
Figure 265: Installing the Cable Module
DLP-G655 Route and Lock Cables
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 Route the ECU cables on both the ECU ejectors.
an example of ECU cable routing. This allows you to close the front door. Ensure an extra length of ECU
cable is available to allow cable management during extraction of the power module. See Diagram 1 of
269: Sequence to Remove the Power Module, on page
power module without adding the extra length of ECU cable by reducing the number of cables in the right
exit area (see Diagram 1 of
required in the left exit area to manage the USB connections (see Diagram 2 of
on page
Cisco ONS 15454 Hardware Installation Guide
394
This procedure routes and locks the cables on the ONS 15454 M6 system.
None
None
As needed
Onsite
None
Figure 267: Cable Management, on page
395).
Figure 266: ECU module Cable Routing, on page 395
397. It is also possible to manage the extraction of the
395). An extra length of ECU cable is
Installing the ONS 15454 M6 Shelf
shows
Figure
Figure 267: Cable Management,