Dlp-G9 Open The Front Cabinet Compartment (Door) - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Complete the
Step 2 Complete the
Step 3
If you are using an ETSI shelf, continue with the
on page
Only), on page
Stop. You have completed this procedure.

DLP-G9 Open the Front Cabinet Compartment (Door)

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
The ONS 15454 shelf has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input is
located on the outside of the shelf on the right side. It is labeled "ESD" on the top and bottom. Always wear
an ESD wrist strap and connect the strap to the ESD plug when working on the ONS 15454. For detailed
instructions on how to wear the ESD wristband, refer to the
Cisco CPT and Cisco ONS
Open-end wrench
Pinned hex (Allen) key
NTP-G306 Install the ONS 15454 Shelf, on page 31
Required
Onsite
None
DLP-G9 Open the Front Cabinet Compartment (Door) , on page
DLP-G10 Remove the Front Door , on page
60. If you are using an ANSI shelf, continue with the
63.
This task opens the front door.
Pinned hex (Allen) key
NTP-G306 Install the ONS 15454 Shelf, on page 31
Required
Onsite
None
Platforms.
DLP-G9 Open the Front Cabinet Compartment (Door)
58.
NTP-G4 Open and Remove the FMEC Cover (ETSI Only),
NTP-G5 Remove the Backplane Covers (ANSI
Electrostatic Discharge and Grounding Guide for
Cisco ONS 15454 Hardware Installation Guide
57.
57