Ntp-G12 Install And Close The Fmec Cover (Etsi Only) - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Figure 58: Alarm Output Connector
Step 4
Continue with the
Stop. You have completed this procedure.

NTP-G12 Install and Close the FMEC Cover (ETSI Only)

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
NTP-G13 Install the Rear Cover (ANSI Only), on page 118
This procedure installs and closes the ONS 15454 ETSI FMEC cover.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), on page 60
Required
Onsite
None
NTP-G12 Install and Close the FMEC Cover (ETSI Only)
as needed.
Cisco ONS 15454 Hardware Installation Guide
117