Ntp-G270 Open And Remove The Standard Door Of The Ons 15454 M2 Shelf - Cisco ONS 15454 Hardware Installation Manual

NTP-G270 Open and Remove the Standard Door of the ONS 15454 M2 Shelf

Step 5
Tighten the door screws to a torque value of 6.5 in-lb (0.75 N-m) to close the standard door as shown in the
following figure.
Figure 138: Close the Standard Door of ONS 15454 M2 Shelf
Stop. You have completed this procedure.
NTP-G270 Open and Remove the Standard Door of the ONS 15454 M2 Shelf
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Complete the
Step 2 Complete the
Cisco ONS 15454 Hardware Installation Guide
218
This procedure opens and removes the standard door of the ONS 15454 M2.
#2 Phillips Dynamometric screwdriver
• NTP-G266 Install the ONS 15454 M2 Shelf, on page
• NTP-G269 Install the Standard Door of the ONS 15454 M2 Shelf, on page
216.
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer to the
Guide for Cisco CPT and Cisco ONS
Required
Onsite
None
DLP-G594 Open the Standard Door of the ONS 15454 M2 Shelf, on page
DLP-G595 Remove the Standard Door of the ONS 15454 M2 Shelf, on page
Installing the ONS 15454 M2 Shelf
194.
Electrostatic Discharge and Grounding
Platforms.
219.
220.