Dlp-G585 Mounting The Brackets On The Ons 1545 M2 Shelf For Etsi Rack Configuration; Rack Configuration - Cisco ONS 15454 Hardware Installation Manual

DLP-G585 Mounting the Brackets on the ONS 1545 M2 Shelf for ETSI Rack Configuration

Step 16
Return to your originating procedure (NTP).
DLP-G585 Mounting the Brackets on the ONS 1545 M2 Shelf for ETSI Rack Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
Use only the fastening hardware provided with the ONS 15454 M2 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution
When mounting the ONS 15454 M2 in a frame with a nonconductive coating (such as paint, lacquer, or
enamel) either use the thread-forming screws provided with the ONS 15454 M2 ship kit, or remove the coating
from the threads to ensure electrical continuity.
Procedure
Step 1 Place the mounting bracket flush against the shelf as shown in
15454 M2 Shelf for ETSI Rack Configuration, on page
Step 2 Align the mounting bracket screw holes against the shelf screw holes.
Step 3
Insert the screws and tighten them to a torque value of 11.5 in-lb (1.3 N-m).
Step 4 Repeat steps 1 through 3 for the mounting bracket on the opposite side.
Cisco ONS 15454 Hardware Installation Guide
202
This task installs the mounting brackets on the ONS 15454 M2 shelf for ETSI

rack configuration.

Note In an ETSI rack, the air deflectors can be mounted only in the front
position of the chassis.
• #2 Phillips Dynamometric screwdriver
• Medium slot-head screwdriver
• Small slot-head screwdriver
NTP-G305 Unpack and Inspect the ONS 15454, ONS 15454 M2, and ONS 15454
M6 Shelves, on page 20.
As needed
Onsite
None
Installing the ONS 15454 M2 Shelf
Figure 125: Mounting the Brackets on the ONS
203.