Ntp-G304 Configure The Ms-Isc-100T Card For A Ons 15454 Multishelf Node For Non-Default Public And Private Vlan Ids - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Stop. You have completed this procedure.
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454
Multishelf Node for Non-Default Public and Private VLAN IDs
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 At the Cisco IOS command line interface (CLI) for the MS-ISC-100T card, enter the following spanning tree
commands:
Example:
Router(config)#
Router(config)#
Router(config)#
Router(config)#
Router(config)#
Router(config)#
Step 2 Enter the following commands to configure the ports DCN 1 and DCN 2:
Example:
(Router(config)#
(Router(config-if)#
(Router(config-if)#
(Router(config-if)#
(Router(config)#
(Router(config-if)#
(Router(config-if)#
(Router(config-if)#

NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454 Multishelf Node for Non-Default Public and Private VLAN IDs

Use this procedure to configure the MS-ISC-100T Card for a multi-shelf node
for non-default public and private VLAN IDs.
Voltmeter
Applicable procedures in
on page 23
Required
Onsite
None
bridge
public VLAN ID
bridge
public VLAN ID
bridge
public VLAN ID
bridge
private VLAN ID
bridge
private VLAN ID
bridge
private VLAN ID
interface FastEthernet0
no ip address
no ip route-cache
bridge-group
interface FastEthernet1
no ip address
no ip route-cache
bridge-group
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf,
protocol rstp
forward-time 5
max-age 10
protocol rstp
forward-time 5
max-age 10
public VLAN ID
public VLAN ID
Cisco ONS 15454 Hardware Installation Guide
141