Ntp-G271 Install The Power And Ground To The Ons 15454 M2 Shelf - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M2 Shelf

NTP-G271 Install the Power and Ground to the ONS 15454 M2 Shelf

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning
To ensure safety of personnel and equipment, do not connect any power cables into the power module
until the module is completely installed into the chassis. Statement 389
Warning To reduce the risk of electric shock, switch on the power only after the power cord is completely installed
into the power module. Statement 390
NTP-G271 Install the Power and Ground to the ONS 15454 M2 Shelf
This procedure installs power feeds and grounds the ONS 15454 M2 system.
ANSI and ETSI:
• #2 Phillips Dynamometric screwdriver
• Medium slot-head screwdriver
• Small slot-head screwdriver
• Screws
• Ground cable 13.3-mm² (#6 AWG) stranded
• Listed pressure dual-holes lugs suitable for #6 AWG copper conductors
• Wire cutters
• Wire strippers
• Crimp tool
• Fuse panel
ANSI only:
• Power cable (from fuse panel to assembly), #12 AWG, copper conductors,
194 degrees F [90 degrees C])
• Wire wrapper
• Two-hole grounding lug, shipped with the ONS 15454 M2
ETSI only:
• Power cable (from fuse panel to power modules), shipped with the ONS
15454 M2 ETSI
• Two-hole grounding lug, shipped with the ONS 15454 M2
• NTP-G267 Install the Power Module in the ONS 15454 M2 Shelf, on page
230.
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer to the
Guide for Cisco CPT and Cisco ONS
Required
Onsite
None
Cisco ONS 15454 Hardware Installation Guide
Electrostatic Discharge and Grounding
Platforms.
239