Ntp-G5 Remove The Backplane Covers (Ansi Only) - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Step 3
Pull the right side of the hinge-locking spring.
Figure 37: Removing the ONS 15454 FMEC Cover
Step 4
Detach the cover from the pin of the hinge.
Step 5 Remove the cover carefully from the left pin of the hinge.
Step 6
Return to your originating procedure (NTP).

NTP-G5 Remove the Backplane Covers (ANSI Only)

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
This procedure describes how to access the ONS 15454 ANSI backplane by
removing the covers. The backplane has two sheet metal covers (one on either
side) and a lower backplane cover at the bottom.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G306 Install the ONS 15454 Shelf, on page 31
NTP-G3 Open and Remove the Front Door , on page 56
Required
Onsite
Cisco ONS 15454 Hardware Installation Guide
NTP-G5 Remove the Backplane Covers (ANSI Only)
63