Cisco ONS 15454 Hardware Installation Manual page 149
Hide thumbs
Also See for ONS 15454:
- Troubleshooting manual (107 pages) ,
- Manual (88 pages) ,
- Procedure manual (62 pages)
Table of Contents
Advertisement
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Locate the three screws that run vertically along on each side of the backplane. See the following figure.
Figure 60: Backplane Attachment for the Rear Cover
Tip
Step 2
Loosen the top and bottom screws on one edge of the backplane to provide room to slide the mounting brackets
into place using the U-shaped screw slots on each end.
Step 3
Slide one of the mounting brackets into place and tighten the screws.
Step 4
Repeat Steps 2 and 3 for the second mounting bracket.
Step 5
Attach the cover by hanging it from the mounting screws on the back of the mounting brackets and pulling
it down until it fits snugly into place.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
Required
Onsite
None
Only six screws (three on each side) line up with the screw slots on the mounting brackets, making
the screws easy to locate.
NTP-G13 Install the Rear Cover (ANSI Only)
Cisco ONS 15454 Hardware Installation Guide
119
Advertisement
Table of Contents
