Cisco ONS 15454 Hardware Installation Manual page 479

Hide thumbs Also See for ONS 15454:

Table of Contents

Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf

Figure 296: Installing the Door Ground Strap Retrofit Kit

(ANSI only) Attach the other end of the ground strap to the longer screw on the fiber guide.

a) Attach the lock washer.

b) Attach the terminal lug.

c) Using the open-end wrench, attach and tighten the #4 Kepnut (49-0337-01) on the terminal lug.

Replace the left cable-routing channel if it was removed. If not, continue with Step 5.

Using a Phillips screwdriver, insert and tighten the screws for the cable-routing channel.

The following figure shows the shelf assembly with the front door and ground strap installed.

To avoid interference with the traffic (line) card, make sure the ground strap is in a flat position

when the door is open. To move the ground strap into a flat position, rotate the terminal lug

counterclockwise before tightening the Kepnut.

NTP-G40 Replace the Front Door

Cisco ONS 15454 Hardware Installation Guide