Dlp-G593 Install The Dc Power Module In The Ons 15454 M2 Shelf - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M2 Shelf

DLP-G593 Install the DC Power Module in the ONS 15454 M2 Shelf

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 Insert the DC power module in Slot A (see the following figure).
Figure 156: Installing the DC Power Module
Step 2 Plug the DC power module completely into the chassis.
Step 3 Tighten the screw to a torque value of 4 in-lb (0.45 N-m) to lock the power module in the chassis (see the
following figure).
DLP-G593 Install the DC Power Module in the ONS 15454 M2 Shelf
This task installs the DC power module in the ONS 15454 M2 system.
#2 Phillips Dynamometric screwdriver
• NTP-G266 Install the ONS 15454 M2 Shelf, on page
• Connect the chassis to the office ground. For detailed instructions on how
to ground the chassis, refer to the
Guide for Cisco CPT and Cisco ONS Platforms
Required
Onsite
None
Cisco ONS 15454 Hardware Installation Guide
194.
Electrostatic Discharge and Grounding
.
233