Dlp-G33 Install The Tcc2, Tcc2P, Or Tcc3 Card - Cisco ONS 15454 Hardware Installation Manual

DLP-G33 Install the TCC2, TCC2P, or TCC3 Card

Note If protective clips are installed on the backplane connectors of the cards, remove the clips before installing
the cards.
Note If you install a card incorrectly, the FAIL LED flashes continuously.
Procedure
Step 1 (Cisco ONS 15454 only) Complete the
Note
Step 2
(Cisco ONS 15454 only) Complete the
Step 3 (Cisco ONS 15454 only) Complete the
Stop. You have completed this procedure.
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
Do not remove a TCC2/TCC2P/TCC3 card during the software transfer process, which is indicated by alternate
flashing FAIL and ACT/STBY LEDs. Removing a TCC2/TCC2P/TCC3 during the software transfer process
will corrupt the system memory.
Note Allow each card to boot completely before installing the next card.
Cisco ONS 15454 Hardware Installation Guide
132
If you install the wrong card in a slot, see the
Replace DWDM Cards procedure.
This task installs redundant TCC2/TCC2P/TCC3 cards. The first card you install
in the ONS 15454 must be a TCC2/TCC2P/TCC3 card, and it must initialize
before you install any cross-connect or traffic cards. Cross-connect cards are only
required in hybrid nodes.
Two TCC2/TCC2P/TCC3 cards
None
Required
Onsite
None
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card , on page
NTP-G107 Remove Permanently or Remove and
DLP-G34 Install the AIC-I Card, on page
DLP-G309 Install the MS-ISC-100T Card , on page
132.
135, if necessary.
136, if necessary.