Dlp-G3 Reverse The Mounting Bracket To Fit A 19-Inch (482.6-Mm) Rack (Ansi Only) - Cisco ONS 15454 Hardware Installation Manual

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Stop. You have completed this procedure.
DLP-G3 Reverse the Mounting Bracket to Fit a 19-inch (482.6-mm) Rack (ANSI
Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution
Use only the fastening hardware provided with the ONS 15454 ANSI to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution When mounting the ONS 15454 in a frame with a nonconductive coating (such as paint, lacquer, or enamel)
either use the thread-forming screws provided with the ONS 15454 ANSI ship kit, or remove the coating from
the threads to ensure electrical continuity.
Procedure
Step 1
Remove the screws that attach the mounting bracket to the side of the shelf.
Step 2 Flip the detached mounting bracket upside down.
Text imprinted on the mounting bracket will now also be upside down.
Step 3 Place the widest side of the mounting bracket flush against the shelf (see
Brackets (23-inch [584.2-mm] Position to 19-inch [482.6-mm] Position, on page
The narrow side of the mounting bracket should be towards the front of the shelf. Text imprinted on the
mounting bracket should be visible and upside down.
Step 4
Align the mounting bracket screw holes against the shelf screw holes.
Step 5 Insert the screws that were removed in Step 1 and tighten them.
Step 6
Repeat the task for the mounting bracket on the opposite side.

DLP-G3 Reverse the Mounting Bracket to Fit a 19-inch (482.6-mm) Rack (ANSI Only)

This task installs the mounting bracket to convert a 23-inch (584.2 mm) rack to
a 19-inch (482.6-mm) rack. This task applies to ONS 15454 ANSI shelves only.
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
None
As needed
Onsite
None
Cisco ONS 15454 Hardware Installation Guide
Figure 12: Reversing the Mounting
34).
33