Cisco ONS 15454 Hardware Installation Manual page 414

DLP-G573 Connect Office Power (DC) to the ONS 15454 M6 Shelf (ETSI Only)
Figure 260: Connecting Office Power—DC Power Modules (ETSI Only)
Note
Note
Caution
Caution
Step 6 Return to your originating procedure (NTP).
Table 34: PIDs for DC Power Cables
Cable
DC power cable for ETSI left exit
DC power cable for ETSI right exit
Cisco ONS 15454 Hardware Installation Guide
384
For slot A power module, use the left power cable—15454-M6-DCCBL-LE, and for slot B use the
right power cable—15454-M6-DCCBL-RE. Use 15454-M6-DCCBL2-L and 15454-M6-DCCBL2-R
cables for the 15454-M6-DC40 power module. For slot A power module, the power cable exits
from the left side. For slot B power module, the power cable exits from the right side
Use only pressure terminal connectors, such as ring and fork types, when terminating the battery,
battery return, and frame ground conductors.
Before you make any crimp connections, coat all bare conductors (battery, battery return, and frame
ground) with an appropriate antioxidant compound. Bring all unplated connectors, braided strap,
and bus bars to a bright finish, then coat with an antioxidant before you connect them. You do not
need to prepare tinned, solder-plated, or silver-plated connectors and other plated connection surfaces,
but always keep them clean and free of contaminants.
When terminating power, return, and frame ground, do not use soldering lug, screwless (push-in)
connectors, quick-connect, or other friction-fit connectors.
PID
15454-M6-DCCBL-LE=
15454-M6-DCCBL-RE=
Installing the ONS 15454 M6 Shelf