Cisco ONS 15454 Hardware Installation Manual page 143

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Procedure
Step 1
Position the lower cover over the AEP. Make sure that the AEP AMP Champ connectors protrude through
the cutouts in the lower cover as shown in the following figure.
Figure 56: Installing the AEP Cover
Step 2
Insert and tighten the eight screws to secure the AEP cover to the AEP.
Step 3 Connect the cables from the external wire-wrap panel to the AMP Champ connectors on the AEP. The following
table lists the alarm input pin assignments.
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only)
Cisco ONS 15454 Hardware Installation Guide
113