Table of Contents
Advertisement
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
Figure 8: Attach the Cable Management Arm to the Rear of the Slide Rails
1
CMA tab on arm farthest from server and end of
stationary outer slide rail
2
CMA tab on arm closest to the server and end of
inner slide rail attached to server
Reverse the Cable Management Arm (Optional)
Step 1
Rotate the entire CMA assembly 180 degrees. The plastic cable guides must remain pointing upward.
Step 2
Flip the tabs at the end of each CMA arm so that they point toward the rear of the server.
Step 3
Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab
and pivot the tab 180 degrees so that it points toward the rear of the
3
4
Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide
Reverse the Cable Management Arm (Optional)
CMA tab on width-adjustment slider and end of
stationary outer slide rail
Rear of server
19
Advertisement
Table of Contents
