Siemens SINUMERIK 840D sl Series Diagnostics Manual page 68

Overview of Alarms
Parameters: %1 = TO unit
%2 = Tool identifier (name)
%3 = Duplonummer
%4 = D number
Definitions: Tool monitoring: This message informs that the specified D offset has reached its pre-
warning limit for a time-, quantity- or wear-monitored tool. If possible, the D number is dis-
played; if not, value 0 is assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active
instead of tool wear monitoring.
The actual type of tool monitoring is a tool property (see $TC TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm is triggered through the MMC or PLC (=OPI interface). The channel context is
not defined. The TO unit was specified for this reason (see $MC_MM_LINK_TOA_UNIT).
Reactions: - Interface signals are set.
- Alarm display.
Remedy: For information only. The user must decide what to do.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6413
Channel %1 tool %2 / Duplo no. %3 has reached its monitoring limit with D = %4
Parameters: %1 = TO unit
%2 = Tool identifier (name)
%3 = Duplonummer
%4 = D number
Definitions: Tool monitoring: This message informs that the specified D offset has reached its pre-
warning limit for a time-, quantity- or wear-monitored tool. If possible, the D number is dis-
played; if not, value 0 is assigned to the 4th parameter.
If the function additive offset is being used, additive offset monitoring may be active
instead of tool wear monitoring.
The actual type of tool monitoring is a tool property (see $TC TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm originates during NC program execution.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: For information only. The user must decide what to do.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
6415
TO unit %1 tool %2 with tool edge no. %3 has reached tool monitor warning limit
Parameters: %1 = TO unit
%2 = Tool identifier
%3 = Cutting edge number
Definitions: This message informs that at least one cutting edge of the time or quantity monitored tool
has reached its monitoring limit. The alarm was triggered through the OPI interface
(MMC, PLC). The channel context is not defined. The TO unit was specified for this rea-
son.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: For information only. The user must decide what to do.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
2-68
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005