Siemens SINUMERIK 840D sl Series Diagnostics Manual page 459

08/2005
Remedy: Select a new tool type.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61213
Channel %1 block %2: Circle radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed circle radius is too small.
Alarm triggered by following cycles: CYCLE77, E_CR_HEL, E_PI_CIR, E_PO_CIR,
E_PO_REC, F_PI_CIR, F_PO_CIR, F_PO_REC
Remedy: Correct the circle radius, center point or end point.
61214
Channel %1 block %2: No lead programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No lead/helical lead has been entered.
Alarm triggered by following cycles: E_CR_HEL, E_PO_CIR, E_PO_REC, F_PO_CIR,
F_PO_REC.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Program a lead.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61215
Channel %1 Block %2: Unfinished dimension incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Check the blank spigot dimensions. The blank spigot must be larger than the production
part spigot.
Alarm triggered by following cycles: CYCLE76, CYCLE77, E_PI_CIR, E_PI_REC,
E_PO_CIR, E_PO_REC, F_PI_CIR, F_PI_REC, F_PO_CIR, F_PO_REC
Remedy: Check parameters _AP1 and _AP2.
61216
Channel %1 Block %2: Feed/tooth only possible with cutting tools
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Feed per tooth is only possible with milling tools.
Alarm triggered by following cycles: E_TFS, F_TFS.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: As alternative, set a different feed type.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61217
Channel %1 Block %2: Cutting speed programmed for tool radius 0
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-459