Siemens SINUMERIK 840D sl Series Diagnostics Manual page 302

Overview of Alarms
• Select different H number
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17188
Channel %1 D number %2 defined in tool T no. %3 and %4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = T number of first tool
%4 = T number of second tool
Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T
numbers %3 and %4 each have an offset with number %2. If tool management is active:
The specified T numbers belong to tool groups with different names.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique.
2. If unique numbering is not necessary for subsequent operations, do not use the com-
mand.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
17189
Channel %1 D number %2 of tools defined on magazine/location %3 and %4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = Magazine/location number of first tool, '/' as separator
%4 = Magazine/location number of second tool, '/' as separator
Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T
numbers %3 and %4 each have an offset with number %2.
If tool management is active:
The specified T numbers belong to tool groups with different names.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique, e.g. by renaming the D num-
bers.
2. If unique numbering is not necessary for subsequent operations, do not use the com-
mand.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
17190
Channel %1 block %2 illegal T number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the displayed block, access is made to a tool that is not defined and therefore not avail-
able. The tool has been named by its T number, its name or its name and duplo number.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Check tool call in the NC part program:
• Correct tool number T.. programmed?
• Tool parameters P1 - P25 defined? The dimensions of the tool edge must have been
entered previously either through the operator panel or through the V.24 interface.
Description of the system variables $P_DP x [n, m]
2-302
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005