Siemens SINUMERIK 840D sl Series Diagnostics Manual page 494

Overview of Alarms
Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Check value in parameter _VARI.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61701
Channel %1 block %2: Error in finished part contour description
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Either none of parameters _NP1, _NP2 and _NP3 supplied or error in finished-part con-
tour programming.
Remedy: • Check parameters _NP1, _NP2 and _NP3.
• Check finished-part contour programming.
61702
Channel %1 block %2: Error in blank contour description
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Either none of parameters _NP5, _NP6 and _NP7 supplied or error in blank contour pro-
gramming.
The alarm is triggered by the following cycles: CYCLE950
Remedy: • Check parameters _NP5, _NP6 and _NP7.
• Check blank contour programming.
61703
Channel %1 block %2: Internal cycle error while deleting file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61704
Channel %1 block %2: Internal cycle error while writing to file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61705
Channel %1 block %2: Internal cycle error while reading to file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
2-494
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005