Siemens SINUMERIK 840D sl Series Diagnostics Manual page 621

08/2005
Cause: Firmware was not able to be downloaded into a DRIVE-CLiQ component.
Fault value (r0949):
xxyyyy hex: xx = component number, yyyy = cause of the fault.
Cause of the fault (decimal):
011: DRIVE-CLiQ component has detected a checksum error.
015: The selected DRIVE-CLiQ component did not accept the contents of the firmware file.
101: After several communication attempts, not response from the DRIVE-CLiQ
component.
140: Firmware file for the DRIVE-CLiQ component not available on the CompactFlash
Card.
143: Component is not changed in the firmware download mode.
156: Component with the specified component number is not available (p7828).
Additional values:
Only for internal Siemens troubleshooting.
Remedy: - check the selected component number (p7828).
- check the DRIVE-CLiQ connection.
- save suitable firmware file for download in the directory /siemens/sinamics/code/sac/.
- after POWER ON has been carried-out again for the DRIVE-CLiQ component, download
the firmware again.
201006 <location>Firmware update DRIVE-CLiQ component required
Reaction: NONE
Acknowledge: NONE
Cause: The firmware of a DRIVE CLiQ component must be updated as there is no suitable
firmware or firmware version in the component for operation with the control unit.
Alarm value (r2124, decimal):
Component number of the DRIVE-CLiQ component.
Remedy: Firmware update using the commissioning software:
The firmware version of all of the components on the "version overview" page can be read
in the Project Navigator under "Configuration" of the associated drive unit and an
appropriate firmware update can be carried-out.
Firmware update via parameter:
- take the component number from the alarm value and enter into p7828.
- start the firmware download with p7829 = 1.
201007 <location>POWER ON DRIVE-CLiQ component required
Reaction: NONE
Acknowledge: NONE
Cause: A DRIVE-CLiQ component must be powered-up again (POWER ON) as, for example, the
firmware was updated.
Alarm value (r2124, decimal):
Component number of the DRIVE-CLiQ component.
Remedy: Switch-out the power supply of the specified DRIVE-CLiQ component and switch-in again.
201010 <location>Drive type unknown
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: An unknown drive type was found.
Fault value (r0949, decimal):
Drive object number.
Remedy: Check the EEPROM data of the drive objects.
201015 <location>Internal software error
Reaction: OFF2
Acknowledge: POWER ON
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-621