Siemens SINUMERIK 840D sl Series Diagnostics Manual page 561

08/2005
The following is valid up to SW 4.1:
The correction block window can be opened in the "Stop program" state.
The program that is currently being executed is opened for editing.
The program part that has not yet been recorded by the NCK's
program processing can be changed permanently.
Remedy: --
103001
Selection only possible after enable or in RESET state
Definitions: In order to execute the desired function, the current channel has to be in the RESET
state, e.g. "Program selection".
Remedy: Trigger reset.
103002
Copying to clipboard not possible
Definitions: The NCK rejects a copy-action to the clipboard because, for example, no more memory is
available or the maximum manageable amount of programs has been exceeded.
Remedy: Delete the programs not currently required.
103003
MDI buffer cannot be deleted
Definitions: The NCK rejects a deletion of the clipboard because the clipboard is currently being exe-
cuted.
Remedy: Wait until the MDI program has been executed or trigger an NC reset.
103004
Block search not possible
Definitions: The search run cannot be started because the channel is active.
Remedy: Wait until the program has been executed or trigger an NC reset.
103005
Block search backwards only possible without calculation
Definitions: --
Remedy: --
103006
Block search without calculation possible on MP level only
Definitions: No subroutine calls can be processed during a block search without calculation.
Remedy: If subroutines are to be processed, a search run with calculation has to be performed.
103007
You cannot terminate overstore in this channel state
Definitions: Overstore cannot be ended because the channel is still active.
Remedy: Wait until the overstore procedure has finished or trigger an NC reset.
103008
Block search started in channel %1 - please wait !
Parameters: %1 = Channel number
Definitions: The started block search is not yet finished.
Remedy: Text is deleted automatically after the end of the block search.
Wait until the block search has finished or trigger an NC reset.
103009
Conflict between search type and search target !
Definitions: The search target entered is not compatible with the search type:
The block number initial character "N" or ":" is missing,
only the digits 0 to 9 are allowed.
Remedy: Correct the entry to correspond with the type.
The following is valid up to SW 3.x: The faulty entry is deleted, and the cursor proceeds to
the next field.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-561