Siemens SINUMERIK 840D sl Series Diagnostics Manual page 616

Overview of Alarms
Remedy: Part program %2 can only be assigned to a channel in an NCU configured in NET-
NAMES.INI.
129933
DAT: The configured channel (%1) for part program %2 in NCU %3 is invalid.
Parameters: %1 = Channel number
%2 = Name of the part program
%3 = Name of the NCU according to NETNAMES.INI
Definitions: The specified combination of NCU, part program and channel is invalid for time measur-
ing of the configured workpiece.
Remedy: Correct the corresponding entry in the DAT file belonging to the workpiece.
129934
DAT: Part program %1 has been configured more than once.
Parameters: %1 = Name of the part program
Definitions: For time measuring of the configured workpiece, the specified part program is configured
for several channels.
Remedy: Correct the corresponding entry in the DAT file belonging to the workpiece.
129935
NC configuration not yet determined.
Definitions: Unable to determine the configuration of the NCs.
Remedy: Ensure that communication to the NC has been activated and all machine data required
for time measuring have been set correctly.
129936
Initialization not yet executed.
Definitions: An order has been sent to the ITS server although the server has not been initialized yet.
Remedy: Execute your operation again later.
129937
Workpiece selection missing.
Definitions: The ITS server has not yet received any DAT file for time measuring, or the contents of
the DAT file is faulty.
Remedy: Select a workpiece for execution prior to executing a time measurement.
129938
Status of workpiece (%1) could not be determined.
Parameters: %1 = Workpiece name
Definitions: The state ?editable? of the DAT file or the workpiece could not be determined.
Remedy: Restart communication to the NC, if required.
129939
Workpiece (%1) is currently being edited.
Parameters: %1 = Workpiece name
Definitions: The DAT file or workpiece is currently disabled.
Remedy: Close the open DAT file or the corresponding workpiece in MCSE, if required.
129940
Error in workpiece (%1).
Parameters: %1 = Workpiece name
Definitions: The ITS server has not yet been initialized, it cannot, therefore, execute the order.
Remedy: Execute your operation again later.
129941
Not all involved channels are in RESET.
Definitions: At least one of the channels configured in the workpiece for time measuring is not in the
"Reset" state.
2-616
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005