Siemens SINUMERIK 840D sl Series Diagnostics Manual page 446

Overview of Alarms
- Interpreter stop
Remedy: Check parameters _LENG and _WID.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61119
Channel %1 Block %2: Nominal or core diameter programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The nominal or core diameter was incorrectly programmed. Alarm triggered by following
cycles: CYCLE70, E_MI_TR, F_MI_TR.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check thread geometry.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61120
Channel %1 Block %2: Thread type inside / outside not defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The thread type (internal/external) was not defined. Alarm triggered by following cycles:
CYCLE70.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: The internal/external thread type must be entered.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61121
Channel %1 Block %2: Number of teeth per cutting edge is missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value was entered for the number of teeth per cutting edge. Alarm triggered by follow-
ing cycles: CYCLE70.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter the number of teeth/cutting edges for the active tool into the tool list.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61122
Channel %1 Block %2: Safety distance incorrectly defined in plane
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The safety clearance is negative or zero. This is not allowed.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
2-446
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005