Siemens SINUMERIK 840D sl Series Diagnostics Manual page 438

Overview of Alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61006
Channel %1 Block %2: Tool radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too large for machining. Alarm triggered by following cycles:
CYCLE930, CYCLE951, E_CP_CE, E_CP_CO, E_CP_DR, E_PO_CIR, E_PO_REC,
F_CP_CE, F_CP_CO, F_CP_DR, F_PO_CIR, F_PO_REC.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a smaller tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61007
Channel %1 Block %2: Tool radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too small for machining. Alarm triggered by following cycles: CYCLE92,
E_CP_CO, E_SL_CIR, F_CP_CO, F_PARTOF, F_SL_CIR.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a larger tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61008
Channel %1 Block %2: No tool active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles:
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: .
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61009
Channel %1 Block %2: Active tool number = 0
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No tool (T) has been programmed before the cycle call. Alarm triggered by following
cycles: CYCLE71, CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
2-438
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005