Siemens SINUMERIK 840D sl Series Diagnostics Manual page 534

Overview of Alarms
Program Con- Switch control OFF - ON.
tinuation:
75210
RCTR: Channel: %1, number of axes/axis assignment inconsistent
Parameters: %1 = Channel number
Definitions: On transformation selection an incorrect axis assignment is detected:
The axes entered in MD TRAFO_AXES_IN_1 do not match MD TRAFO6_NUM_AXES.
Reactions: - Interpreter stop
- Alarm display.
Remedy: Correct machine data.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75212
RCTR: channel %1, incorrect TRAFO_TYPE_ : use 4100
Parameters: %1 = Channel number
Definitions: The transformer type entered in MD TRAFO_TYPE_x is incorrect
Reactions: - Interpreter stop
- Alarm display.
Remedy: TRAFO_TYPE 4100 is to be used
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75250
RCTR: channel %1, tool parameters incorrect interpreter
Parameters: %1 = Channel number
Definitions: On block interpretation incorrect tool parameters are detected:
Reactions: - Interpreter stop
- Alarm display.
Remedy: Correct tool parameters.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75255
RCTR: channel: %1, unreachable position interpreter
Parameters: %1 = Channel number
Definitions: On block interpretation a non-approachable position is detected:
Reactions: - Interpreter stop
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75260
RCTR: channel: %1, block: %2, tool parameters incorrect on block editing
Parameters: %1 = Channel number
%2 = Block number
Definitions: On block editing incorrect tool parameters are detected:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct tool parameters.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-534
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005