Siemens SINUMERIK 840D sl Series Diagnostics Manual page 591
Hide thumbs
Also See for SINUMERIK 840D sl Series:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
08/2005
Program Con-
Internal
tinuation:
111303
Spindle stop key defective
Definitions:
Acknowledgement to the PLC user program, that the spindle stop key is defective, i.e.,
NC and NO signal = 1.
Reactions:
- NC Start disable in this channel.
- Alarm display.
Remedy:
Replace the key.
Program Con-
Internal
tinuation:
111304
Connection to the PLC broken off
Definitions:
Acknowledgement to the PLC user program, that the connection with MANUALTURN has
been broken off.
Reactions:
- Alarm display.
Remedy:
Check the PLC user program.
Program Con-
Internal
tinuation:
111305
Asynchronous subroutine was not executed
Definitions:
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurrs, these settings cannot be car-
ried out.
Reactions:
- Alarm display.
Remedy:
Perform an NCK reset
Program Con-
Internal
tinuation:
111306
Error when selecting or deselecting constant cutting speed
Definitions:
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurrs, these settings cannot be car-
ried out.
Reactions:
- Alarm display.
Remedy:
Perform an NCK reset
Program Con-
Internal
tinuation:
111307
Error when deleting handwheel offset
Definitions:
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurrs, these settings cannot be car-
ried out.
Reactions:
- Alarm display.
Remedy:
Perform an NCK reset
Program Con-
Internal
tinuation:
111308
Error when setting upper spindle speed limit
Definitions:
In the asynchronous subroutine, internal settings in the NC were triggered by the operator
panel. If one of the alarms from 111306 to 111310 occurrs, these settings cannot be car-
ried out.
Reactions:
- Alarm display.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-591
Hide quick links:
Advertisement
Chapters
Table of Contents
