Siemens SINUMERIK 840D sl Series Diagnostics Manual page 517

08/2005
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62910
Channel %1 block %2: Error while calculating the contour orientation
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62911
Channel %1 block %2: Error on overwriting target
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62912
Channel %1 block %2: Plane cannot be specified here
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62913
Channel %1 block %2: Inch/metric indication not allowed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-517