Siemens SINUMERIK 840D sl Series Diagnostics Manual page 101

08/2005
Remedy: Setting data: Check 43420 WORKAREA_LIMIT_PLUS and 43430
WORKAREA_LIMIT_MINUS for the working area limitation.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
10640
[up to SW 3.x only] Channel %1 block %3 spindle %2 cannot stop during gear
change
Parameters: %1 = Channel number
%2 = Spindle number
%3 = Block number, label
Definitions: The spindle is in the oscillating mode for a gear change and is waiting for the PLC
acknowledgement stating that the gear change has taken place (interface signal: Gear
has changed DB 31 - 48, DBX 16.3). During this phase spindle stop is not possible, initi-
ated by Reset (DB 21 - 28, DBX 7.7) or NC Stop axes plus spindle (DB 21 - 28, DBX 7.4).
Reactions: - Alarm display.
Remedy: No remedial measures are necessary. The spindle-specific interface signal Spindle reset
(DB 31 - 48, DBX 2.2) cancels the oscillation mode.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
10650
Channel %1 axis %2 incorrect gantry machine data, error code %3
Parameters: %1 = Channel number
%2 = Axis
%3 = Error no.
Definitions: An incorrect value was entered in the gantry-specific axial machine data. Further informa-
tion can be derived from the error number.
• Error no. = 1 => either an incorrect gantry unit has been entered or the designation of
the following axis is incorrect.
• Error no. = 2 => master axis has been specified more than once.
Reactions: - NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Correct the machine data:
MD 37100 GANTRY_AXIS_TYPE
0: No gantry axis 1: Master axis grouping 1 11: Slave axis grouping 1 2: Master axis
grouping 2 12: Slave axis grouping 2 3: Master axis grouping 3 13: Slave axis grouping 3
Program Con- Switch control OFF - ON.
tinuation:
10651
Channel %1 gantry configuration error. Error code %2
Parameters: %1 = Channel number
%2 = Reason
Definitions: The gantry configuration set in the machine data is erroneous. Gantry unit and reason for
objection can be found in the transfer parameter.
The transfer parameter is made up as follows.
• %2 = error designation + gantry unit (XX).
• %2 = 10XX => no master axis declared
• %2 = 20XX => no slave axis declared
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-101