Siemens SINUMERIK 840D sl Series Diagnostics Manual page 674

Overview of Alarms
Cause: The trace has already been started.
See also: p4700
Remedy: Stop the trace and, if necessary, start again.
202055 <location>Trace: Recording time too short
Reaction: NONE
Acknowledge: NONE
Cause: The trace duration is too short.
The minimum is twice the value of the trace clock cycle.
See also: p4721
Remedy: Check the selected recording time and, if necessary, adjust.
202056 <location>Trace: Recording cycle too low
Reaction: NONE
Acknowledge: NONE
Cause: The selected recording cycle is shorter than the selected basis clock cycle 0 (p0110[0]).
See also: p4720
Remedy: Increase the value for the trace cycle.
202057 <location>Trace: Invalid time slice clock cycle
Reaction: NONE
Acknowledge: NONE
Cause: The time slice cycle selected does not match any of the existing time slices.
See also: p4723
Remedy: Input an existing time slice cycle. The existing time slices can be read out via p7901.
See also: r7901
202060 <location>Trace: Signal to be recorded is missing
Reaction: NONE
Acknowledge: NONE
Cause: - a signal to be traced was not specified.
- the specified signals are not valid.
See also: p4730, p4731, p4732, p4733
Remedy: - specify the signal to be traced.
- check whether the relevant signal can be traced.
202061 <location>Trace: Invalid signal
Reaction: NONE
Acknowledge: NONE
Cause: - the specified signal does not exist.
- the specified signal can no longer be traced (recorded).
See also: p4730, p4731, p4732, p4733
Remedy: - specify the signal to be traced.
- check whether the relevant signal can be traced.
202062 <location>Trace: Trigger signal invalid
Reaction: NONE
Acknowledge: NONE
Cause: - a trigger signal was not specified.
- the specified signal does not exist.
- the specified signal is not a fixed-point signal.
- the specified signal cannot be used as trigger signal for the trace.
See also: p4711
Remedy: Specify a valid trigger signal.
2-674
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005