Siemens SINUMERIK 840D sl Series Diagnostics Manual page 532

Overview of Alarms
75051
Channel %1 CC_COPON CC_COPOFF error code %2
Parameters: %1 = Channel number
%2 = Error code
Definitions: Error code = 1: Wrong argument programmed
Error code = 10: An axis for which no coupling has been defined, was programmed in
CC_COPON (axis identifier).
Error code = 20: Too many arguments programmed.
Error code = 100: Internal error
Error code = 200: Internal error
Reactions: - Interpreter stop
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75060
Channel %1 tolerance window exceeded axis %2
Parameters: %1 = Channel number
%2 = Axis name
Definitions: The actual position value difference between the CC_Slave axis indicated in the alarm
message and its CC_Master axis is outside the configured tolerance window.
Reactions: - NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Remedy: Check configured tolerance window.
Compare dynamic response settings of coupled axes.
Check mechanical components of axes.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75061
Channel %1 MD modification on active coupling axis %2
Parameters: %1 = Channel number
%2 = Axis name
Definitions: Machine data MD 63000 CC_MASTER_AXIS has been changed when the coupling was
active.
Reactions: - Alarm display.
- NC Stop on alarm.
Remedy: Reset machine data to its old value, switch off the coupling and then enter the new value.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
75062
Channel %1 axes to be coupled are not in standstill axis %2
Parameters: %1 = Channel number
%2 = Axis name
Definitions: The CC_Master and/or CC_Slave axes were not at standstill when the coupling was
switched on.
Reactions: - Alarm display.
- NC Stop on alarm.
Remedy: Input G601 for path axes or program a stop preprocessor (STOPRE) before coupling with
CC_COPON.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-532
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005