Siemens SINUMERIK 840D sl Series Diagnostics Manual page 595

08/2005
This alarm is only a warning.
Residual material will remain.
Reactions: - Alarm display.
Remedy: By using a smaller milling cutter, the machining could be done with an insertion point.
Program Con- Internal
tinuation:
112046
Main contour cannot be traced
Definitions: The pocket contour cannot be bypassed with the specified milling cutter.
Residual material will remain.
The program can be started.
This alarm is only a warning.
Reactions: - Alarm display.
Remedy: By using a smaller milling cutter, the pocket contour could be bypassed.
Program Con- Internal
tinuation:
112052
No residual material available
Definitions: No residual material has been determined.
Reactions: - Alarm display.
Remedy: Check parameters in the residual material cycle.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112057
Programmed helix violates contour
Definitions: The starting point for helical insertion was so selected, that the helix violates the pro-
grammed contour.
The program can be started.
This alarm is only a warning.
Reactions: - Alarm display.
Remedy: Select another starting point; use a smaller helix radius.
Program Con- Internal
tinuation:
112099
System error contour pocket %1
Definitions: While the contour pocket was being calculated, an error occurred. The contour pocket
cannot be calculated.
The program cannot be started.
Reactions: - Alarm display.
Remedy: Make a note of the error text and contact the Siemens AG, A&D MC hotline.
Program Con- Internal
tinuation:
112100
Error on renumbering.%nInitial state restored.
Definitions: The softkey "Renumber" was pressed in the program editor. This caused an error during
serial numbering that damaged the program in the memory, making it necessary to reload
the initial program into the memory. The program was not renumbered.
Reactions: - Alarm display.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-595