Siemens SINUMERIK 840D sl Series Diagnostics Manual page 441

08/2005
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61019
Channel %1 Block %2: Parameter %4 incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE60, CYCLE83.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check the value of the parameter.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61020
Channel %1 block %2: Machining not possible with active TRANSMIT/TRACYL
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61099
Channel %1 block %2: Internal cycle error (%4)
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61101
Channel %1 block %2: Reference plane incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE71, CYCLE72, CYCLE81 to CYCLE90,
CYCLE840, SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: With the relative specification of the depth, either different values for the reference plane
and the retraction plane must be selected or an absolute value must be specified for the
depth.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-441