Siemens SINUMERIK 840D sl Series Diagnostics Manual page 472

Overview of Alarms
- Interface signals are set.
- Alarm display.
Remedy: Reprogram machining.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61265
Channel %1 block %2: Too many restrictions, use rectangular pocket
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling a maximum of only 3 sides can be delimited.
Alarm triggered by following cycle: CYCLE61
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Use pocket cycle.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61266
Channel %1 Block %2: Illegal machining direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling, the delimitations and the direction of machining do not match.
Alarm triggered by following cycle: CYCLE61
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select another direction of machining.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61267
Channel %1 Block %2: Plane infeed too large, residual corners remain
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling, the plane infeed must not exceed 85%.
Alarm triggered by following cycle: CYCLE6
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a smaller plane infeed, as otherwise residual corners will be left over.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61268
Channel %1 block %2: Illegal machining direction, residual corners are left over.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In face milling, the machining direction does not match the selected delimitations.
Alarm triggered by following cycle: CYCLE61.
2-472
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005