Siemens SINUMERIK 840D sl Series Diagnostics Manual page 439

08/2005
Remedy: Program tool (T).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61010
Channel %1 Block %2: Finishing allowance too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The finishing allowance for the base is greater than the total depth. Alarm triggered by fol-
lowing cycle: CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Reduce finishing allowance.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61011
Channel %1 Block %2: Scaling not permissible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A scale factor is active which is illegal for this cycle. Alarm triggered by following cycles:
CYCLE71, CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Modify scale factor.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61012
Channel %1 Block %2: Different scaling in planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE76, CYCLE77.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61013
Channel %1 Block %2: Basic settings were changed, program cannot be executed
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The basic settings are not compatible with the generated program. Alarm triggered by fol-
lowing cycles: E_CP_CE, E_CP_CO, E_CP_DR, F_CP_CE, F_CP_CO, F_CP_DR.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-439