Siemens SINUMERIK 840D sl Series Diagnostics Manual page 601

08/2005
Load contour into the directory.
Program Con- Internal
tinuation:
112503
ShopMill: %1
Definitions: A system error has occurred.
Reactions: - Alarm display.
Remedy: Please contact the hotline of Siemens AG, A&D MC and provide with the error message.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112504
File does not exist or is faulty%n%1
Parameters: %1 = File name
Definitions: The program cannot interpret a program block with contour programming.
Contour not in the directory.
Reactions: - NC Start disable in this channel.
- Alarm display.
Remedy: Load contour into the directory.
Program Con- Internal
tinuation:
112505
Error on interpreting contour:%n%1
Parameters: %1 = Contour name
Definitions: Contour is faulty.
Reactions: - NC Start disable in this channel.
- Alarm display.
Remedy: Check the contour's machining sequence.
Program Con- Internal
tinuation:
112506
Maximum number of contour elements exceeded:%n%1
Definitions: The maximum permissible number of 50 contour elements was exceeded when interpret-
ing the machining sequence of a contour.
Reactions: - Alarm display.
Remedy: Check the contour's machining sequence and, if necessary, edit it.
Program Con- Internal
tinuation:
112541
Program cannot be interpreted
Definitions: The program cannot be interpreted as a ShopMill program during loading, as the program
header is missing.
Reactions: - NC Start disable in this channel.
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
112542
GUD variable does not exist or%narray dimension too small:%1
Definitions: The required GUD variable was not found on read or write access.
Reactions: - Alarm display.
Remedy: Load the correct GUD variable.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-601