Siemens SINUMERIK 840D sl Series Diagnostics Manual page 603

08/2005
Program Con- Internal
tinuation:
112605
Asynchronous subprogram was not executed
Definitions: The input values could not be correctly processed by the NC.
Reactions: - Alarm display.
Remedy: Perform an NCK reset
Program Con- Internal
tinuation:
112611
NC start not possible:%nDeselect single block
Definitions: A program was activated with block search while a single block has been active.
Reactions: - Alarm display.
Remedy: Deselect the single block.
Program Con- Internal
tinuation:
112620
Language %1 not installed.
Definitions: Language not installed.
Reactions: - Alarm display.
Remedy: Install language.
Program Con- Internal
tinuation:
112650
Unknown PLC error
Definitions: The PLC has announced an error that is unknown in the operator panel.
Reactions: - NC Start disable in this channel.
- Alarm display.
Remedy: Press POWER ON, inform Siemens.
Program Con- Internal
tinuation:
112999
Faulty grafic data. Exit graphic and restart
Definitions: More data was generated than can be read from the operator panel.
Stop the graphic.
Remedy: Deselect the graphic and then select it again.
113000
Invalid value - value range: %1
Parameters: %1 = --
Definitions: --
Remedy: --
113001
Incorrect configuration in line %1
Parameters: %1 = --
Definitions: --
Remedy: --
113002
Insufficient access level!
Definitions: --
Remedy: --
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-603