Siemens SINUMERIK 840D sl Series Diagnostics Manual page 421

08/2005
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Adapt cycle time via MD $MN_PROFISAFE_IPO_TIME_RATIO or correct the reduction
of the IPO cycle.
Program Con- Switch control OFF - ON.
tinuation:
27201
PROFIsafe: MD %1[%2]: bus segment %3 error
Parameters: %1 = MD name
%2 = MD array index
%3 = Parameterized bus segment
Definitions: An incorrect bus segment was entered in the specified machine data. The value must be
5.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Correct the MD.
Program Con- Switch control OFF - ON.
tinuation:
27202
PROFIsafe: MD %1[%2]: address %3 error
Parameters: %1 = MD name
%2 = MD array index
%3 = Parameterized PROFIsafe address
Definitions: An incorrect PROFIsafe address was entered in the specified machine data. The value
must be greater than 0.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Correct the MD.
Program Con- Switch control OFF - ON.
tinuation:
27203
PROFIsafe: MD %1[%2]: SPL assignment error
Parameters: %1 = MD name
%2 = MD array index
Definitions: The parameterization of the specified machine data for the link between the SPL interface
and a PROFIsafe module is incorrect because of the following reasons:
• Exchanged bit limits (upper bit value < lower bit value)
• Bit values greater than definition of SPL interface (bit value > 64)
• Number of bits too high for this PROFIsafe module (upper bit value - lower bit value + 1
> 8)
• No SPL assignment parameterized (both bit values equal to zero)
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-421