Siemens SINUMERIK 840D sl Series Diagnostics Manual page 945

08/2005
402402
Parameter ChanNo impermissible in FC24.
Definitions: The parameterized mode group, channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con- Switch control OFF - ON.
tinuation:
402501
Parameter BAGNo impermissible in FC25
Definitions: The parameterized mode group, channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con- Switch control OFF - ON.
tinuation:
402502
Parameter ChanNo impermissible in FC25.
Definitions: The parameterized mode group, channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con- Switch control OFF - ON.
tinuation:
402601
Parameter BAGNo impermissible in FC26
Definitions: The parameterized mode group, channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con- Switch control OFF - ON.
tinuation:
402602
Parameter ChanNo impermissible in FC26
Definitions: The parameterized mode group, channel does not exist.
Reactions: - Alarm display.
Remedy: Correct the parameter.
Program Con- Switch control OFF - ON.
tinuation:
410150
Area in M group decoder list is too large
Definitions: Number of M groups in PLC too large.
Reactions: - Alarm display.
Remedy: Reduce the number of groups
Program Con- Internal
tinuation:
410151
Magazine data for tool management missing in the PLC
Definitions: Magazine data are not available in the PLC. The start-up has not been completed,
although the option TOOLMAN has been activated.
Reactions: - Alarm display.
Remedy: Softkey Create PLC Data must be pressed during TOOLMAN start-up via MMC 103. Data
in data block DB4 must be set from DBB64 in MMC 100.
Program Con- Internal
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-945