Siemens SINUMERIK 840D sl Series Diagnostics Manual page 594

Overview of Alarms
When loading a sequence, a check is run to see whether old cycles were used. If there
are old cycles, the sequence is converted and saved again in the NC. This alarm is output
if an error occurs thereby (memory full).
Reactions: - Alarm display.
Remedy: There must be enough memory for the original sequence and for the backup copy in order
for the sequence to be created.
Program Con- Internal
tinuation:
111900
Start only possible in basic display
Definitions: A G code program can only be started from the basic display of an operating mode
(except MANUAL).
Reactions: - Alarm display.
Remedy: Switch to the basic display of an operating mode (except MANUAL). Start single step
mode with NC start.
Program Con- Internal
tinuation:
111901
Contour is contained in the current program, machining not enabled
Definitions: There is a contour in the current Easystep sequence and it is not permitted to be
changed.
Reactions: - Alarm display.
Remedy: Terminate machining. Reload the Easystep sequence and change it correspondingly.
Program Con- Internal
tinuation:
111902
Start only with valid reference point
Definitions: The axes have no valid reference point.
Reactions: - Alarm display.
Remedy: Reference all axes.
Program Con- Internal
tinuation:
111904
4. Axis not configured, i.e., no driven tool possible
Definitions: 4. The axis is not configured, i.e., no driven tool is possible.
Reactions: - Alarm display.
Remedy: 4. Create an axis. Hereby, the following machine data has to be changed:
Channel-specific 20070 $MC_AXCONF_MACHAX_USED [3]=4
Axis-specific for the 4th axis.
30300 $MA_IS_ROT_AX=1
30310 $MA_ROT_IS_MODULO=1
30320 $MA_DISPLAY_IS_ MODULO=1
30350 $MA_SIMU_AX_VDI_OUTPUT=1
35000 $MA_SPIND_ASSIGN_TO_MACHAX=2
Program Con- Internal
tinuation:
112045
Several approach points required
Definitions: Several insertion points are required for machining the contour pocket. The machining
breaks up into several individual machinings.
The program can be started.
2-594
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005