Siemens SINUMERIK 840D sl Series Diagnostics Manual page 545

08/2005
100202
Channel group outside area (%1): %2
Parameters: %1 = --
%2 = --
Definitions: --
Remedy: --
100203
Channel switchover key not effective
Definitions: --
Remedy: --
100204
Channel on NCU does not exist or is not active
Definitions: --
Remedy: --
100300
'%1' not found, continue search without filter!
Parameters: %1 = --
Definitions: The search term entered in a list image (e.g. general machine data) was not found.
Remedy: --
100301
Table cannot be fully generated!
Definitions: The list image could not be generated due to insufficient memory.
Remedy: System error, a rebooting may be necessary.
100302
No data available - or no access authorization!
Definitions: The list image can not be generated, as this data is currently not available. Example:
Local user data is not defined.
Remedy: --
100303
Paging not possible
Definitions: You cannot page over, for example, axes, drives or channels, as more axes, drives or
channels are not configured.
Remedy: --
100304
'%1' not found.
Parameters: %1 = --
Definitions: --
Remedy: --
100350
Display MD saved
Definitions: • The display machine data is saved via the softkey "Save" in the operating area start-up,
image machine data - display machine data.
• The display machine data is saved in the start-up basic display after pressing the soft-
key "LCD brighter" or "LCD darker" (this setting will remain at the next start-up).
• As of SW 4.1: If the display options are changed in the machine data images, the
change will be saved in the display machine data that is not visible to the user.
Remedy: --
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-545