Siemens SINUMERIK 840D sl Series Diagnostics Manual page 524

Overview of Alarms
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Refer to the manual on user cycles.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
69000
Channel %1 block %2:
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: References: The current alarm text, the error description and the remedial measures for
the user cycle alarms can be found in the Programming Guide of the machine manufac-
turer.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Refer to the manual on user cycles.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
70001
Channel %1 Yf is larger than distance C1-Cy
Parameters: %1 = Channel number
Definitions: In JOG mode, the Yf axis is traversed. The value of the Yf axis is larger than the distance
C1-Cy
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Traverse Yf axis in JOG in opposite traversing direction
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
70002
Channel %1 block %2 Yf has been programmed larger than distance C1-Cy
Parameters: %1 = Channel number
%2 = Block number
Definitions: In the part program, one position in the Yf axis has been programmed larger than the dis-
tance C1-Cy
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
70003
Channel %1 Yf is larger than the effective arm length
2-524
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005