Siemens SINUMERIK 840D sl Series Diagnostics Manual page 489

08/2005
61369
Channel %1 block %2: Position of corner not clearly definable, check parameter
(_SETV[0...7])
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Define P1 and P2 or P3 and P4 in a way that the intersection of the straights determined
by these points is outside the sections formed by P1 and P2 or P3 and P4.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61370
Channel %1 block %2: _PROTVAL[0] -_PROTVAL[5] do not have any entries
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE105.
Remedy: Enter values in _PROTVAL[0...5].
61371
Channel %1 block %2: Product of column width and number of columns exceeds
200 characters per line
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE105.
Remedy: Reduce the column width (_PROTFORM[4]) or number of columns (_PROTVAL[2...5]).
61372
Channel %1 block %2: selected meas.variant requires SPOS-capable spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Change measuring variant or check machine equipment.
61373
Channel %1 block %2: Mono-directional probe requires SPOS-capable spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: Check machine equipment.
61401
Channel %1 block %2: Probe not switching, traversing path limitation through soft-
ware limit position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE961, CYCLE971, CYCLE976,
CYCLE977, CYCLE978, CYCLE998
The position defined by a setpoint value cannot be reached, as the software limit position
has been exceeded.
Remedy: Check specified setpoint value.
61402
Channel %1 block %2: Probe collision, traversing path limitation through software
limit position
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-489