Siemens SINUMERIK 840D sl Series Diagnostics Manual page 661

08/2005
Remedy: Correct the modulo value for SN and carry-out a POWER ON.
Note:
SI: Safety Integrated
SN: Safe software cams
See also: p9505
201688 <location>SI motion: Actual value synchronization not permissible
Reaction: OFF2
Acknowledge: IMMEDIATELY (POWER ON)
Cause: It is not permissible to simultaneously enable the actual value synchronization and a
monitoring function with absolute reference (SE/SN).
Remedy: Either carry-out the monitoring functions with absolute reference (SE/SN) or de-select the
"actual value synchronization" function and carry-out a POWER ON.
Note:
SE: Safe software limit switch
SI: Safety Integrated
SN: Safe software cams
See also: p9501
201698 <location>SI CU: Commissioning mode active
Reaction: NONE
Acknowledge: NONE
Cause: The commissioning of the "Safety Integrated" function is selected.
This message is withdrawn after the safety functions have been commissioned.
Note:
This message does not result in a safety stop response.
See also: p0010
Remedy: None necessary.
Note:
CU: Control unit
SI: Safety Integrated
201699 <location>SI CU: Shutdown path test required
Reaction: NONE
Acknowledge: NONE
Cause: The time set in p9659 for the forced checking procedure of the safety shutdown paths has
been exceeded. The safety shutdown paths must be re-tested.
After the next time that the "safe standstill" function (SH) is de-selected, the message is
withdrawn and the monitoring time is reset.
Note:
This message does not result in a safety stop response.
See also: p9659
Remedy: Select safe standstill and then deselect again.
Note:
CU: Control unit
SH: Safe standstill
SI: Safety Integrated
201700 <location>SI motion: STOP A initiated
Reaction: OFF2
Acknowledge: IMMEDIATELY (POWER ON)
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-661